I would recommend our NW1 White Super Cutting Compound which will go from 1200-1500 grit surface to a glossy finish.

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Sorry to bother again what polishing compound would you recommend
Cheers

Thankyou for the advice 😃😃😃

Where you need to overcoat, you will need to key with 120 grit paper and give it a clean before pouring again.  There will be a very slight seam line on the edge of the new pour, but this can be sanded out and polished back to a gloss finish once the pour has gone hard. 

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Hi ive just poured a penny bar, and it has a couple of places where the resin wasnt poured high enough, or bartop wasn’t completely level.
I’d like to know if i can sand the resin then top the low spots up with fresh resin.
Many thanks