Hi ive just poured a penny bar, and it has a couple of places where the resin wasnt poured high enough, or bartop wasn’t completely level.
I’d like to know if i can sand the resin then top the low spots up with fresh resin.
Many thanks

Where you need to overcoat, you will need to key with 120 grit paper and give it a clean before pouring again.  There will be a very slight seam line on the edge of the new pour, but this can be sanded out and polished back to a gloss finish once the pour has gone hard. 

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Thankyou for the advice 😃😃😃

Sorry to bother again what polishing compound would you recommend
Cheers

I would recommend our NW1 White Super Cutting Compound which will go from 1200-1500 grit surface to a glossy finish.

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant