After i failed with the first part, i would like to start a second try with resin infusion.
Here are some Pictures of the Mould: The mould is about 85 x 25 cm.
Picture 1 side view
It ist a four-part mould. The 4th part is a Polyurethane cast.
Picture 2 inside
Everything necessary for Mounting is inside the cast.
Picture 3 the PU-cast
I could fill the holes with a mixture of chopped carbon fibre strands and resin and let it cure.
After this has cured, i could lay the layers of carbon and the additional layers to get the desired thickness, than the peel ply, perforated Release Film, infusion mesh and then the bag outside of the whole Mould.
Is that a way that may succeed?
Where should i infuse and where to connect the Vacuum?
Another Thing:
It is basically a U-profile with a kink inwards. If I interpret this with 2/2 twill fabric, wrinkles appear on the sidewalls, which I do not get draped away.
regards
Frank