I'm about to embark on my first carbon fiber skinning project on the plastics of my dirt bike (fenders, side panels, etc). But after looking closely at some of the pieces, there are some that have deep indentations where the holes go for the bolts, which has me concerned. The largest ones are up to 5cm in depth and 3cm in diameter (see image of one of my side panels below).

My question is this: is it possible to skin these all the way down to the bottom of the holes, and if so, how would I go about it? I'd really prefer the carbon fiber to go all the way down since these holes are very visible and I want the parts to look like they're completely made of CF.

Any help is greatly appreciated!