Two A-side Carbon Fibre Plate

Author	Message
S_Carbon_fibre	S S_Carbon_fibre posted 7 Years Ago HOT Topic Details
S Group: Forum Members Posts: 17, Visits: 89	Hello, Is there a standard process to manufacture a two A-side carbon fibre plate? Ideally with Vacuum infusion. I still haven't found a tutorial or answer to this. Many thanks for any hint.
	Reply Like 3
Hanaldo	Hanaldo posted 7 Years Ago HOT Post Details
Group: Forum Members Posts: 2.5K, Visits: 28K	It's not really a process suited to infusion, which is why you wont find much about it. The general answer is it can only be done if you're using an internal flow media like Soric or 3D PET core, which obviously limits how thin your plates can be. Solid laminate wont work, you need a flow media. Otherwise, pre-preg is dead easy.
	Reply Like 2
S_Carbon_fibre	S S_Carbon_fibre posted 7 Years Ago HOT Post Details
S Group: Forum Members Posts: 17, Visits: 89	+x Hanaldo - 8/27/2018 11:19:31 PM It's not really a process suited to infusion, which is why you wont find much about it. The general answer is it can only be done if you're using an internal flow media like Soric or 3D PET core, which obviously limits how thin your plates can be. Solid laminate wont work, you need a flow media. Otherwise, pre-preg is dead easy. many thanks for the response. Is there a good tutorial how to do it with pre-preg because I don't see any in the easycomposites youtube channel ? Edited 7 Years Ago by S_Carbon_fibre
	Reply Like 7