f1rob (18/12/2016)

---

All our printed parts are rubbed down then sealed with marbokote 2002
apply five fairly wet coats (getting drier as they build) allow each to air dry naturally and allow at least half hr between coats and try to avoid runs.
when complete oven cure at 50/60 for 1hr
De nib and lightly abrade with 12/1500.
apply your last costly lightly and as dry as you can and allow to air dry overnight an you should have a Finnish like glass that you can then polish for an even better shine or use as is.
Then its just apply your release of choice as you would a "normal" mould