DF 212

Talk Composites - The Forum for Advanced Composites

Back

DF 212

Author	Message
morepower	morepower posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 242, Visits: 1.2K	Cool... Its the best material I have ever used... You will be fine...
	Reply Like 3
scottracing	scottracing posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 460, Visits: 5.2K	just ordered a few metres of it, cant wait to try it out at work as Im trying to eradicate the use of the autoclave
	Reply Like 3
morepower	morepower posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 242, Visits: 1.2K	cpkielycua (06/06/2016) Morepower, I have managed to get a pinhole free surface......on the female side a the part (the "B" side) On the male side, its still full of gaps. Its very bizare. I have used the wax paper and the plastic carrier as releases, both work, but the wax leaves the surface pinhole free. unfortunately I cant use the wax paper on the mould. I get full vacuum and thin parts, but still no luck. OK.. what is your cure schedule? Do you debulk the first layer too? Here you can see this is straight out of the mould... Edited 9 Years Ago by morepower
	Reply Like 4
cpkielycua	cpkielycua posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 29, Visits: 285	Morepower, I have managed to get a pinhole free surface......on the female side a the part (the "B" side) On the male side, its still full of gaps. Its very bizare. I have used the wax paper and the plastic carrier as releases, both work, but the wax leaves the surface pinhole free. unfortunately I cant use the wax paper on the mould. I get full vacuum and thin parts, but still no luck.
	Reply Like 3
scottracing	scottracing posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 460, Visits: 5.2K	cant see the pics
	Reply Like 4
morepower	morepower posted 9 Years Ago HOT Post Details
Group: Forum Members Posts: 242, Visits: 1.2K	Yes..... I use it for all my work.... Infact the curing schedule they use now is the one I did and got to work. So I know their PDF is correct and I would recommend you do use a ramp and dwell controller.. If you do it will work everytime... This is just out of the mould.. Un trimmed. Edited 9 Years Ago by morepower
	Reply Like 4
cpkielycua	cpkielycua posted 9 Years Ago HOT Topic Details
Group: Forum Members Posts: 29, Visits: 285	I have some DF 212 available. Its SHD composites out of autoclave material. I got some as a trial; it does not work for my application. $50 for approv 1 sq meter plus shipping. Cheers
	Reply Like 3