Hi guys, I am still learning and I have been using a small mould as a test.  I have just pulled my small money tray made of 2x2 twill carbon out of the mould and there are tiny pinholes on one side of the surface, I am sure that the bag kept full vac all the way through the infusion so my question is what are the main reasons for a pinhole finish. 

I have been working in the garage which is cold but have my mould on an electric blanket to keep it warm.  the only thing different with this infusion is that I didn't use any spray tack on the surface. 

I am quite happy to have these little problems as I want to learn as much as I can but I need to have an understanding of why things happen and how to improve.

Thanks in advance

Nothing good to say......then say nothing

Yeh I'd say it's a little bit dry for a cosmetic surface. You'll get away with that when everything else is done perfectly, but if you've got some air bubbles in your resin pot from mixing the resin and you infuse a touch too fast then all these little things add up to give you issues like this.