Just some comments on your Bracket "Plugs"    I assume that, since you are going to "pattern" coat them, you are making the "pattern" or "plug" to make the Mold from?

To my eye, you have a lot of very sharp corners on those plugs ... I would put a bit more of a "radius" on all those sharp corners ..  I personally only use smaller radius than 5 mm on very small parts, using very light weight CF weaves.

You may be able to make a usable mold from such a sharp edged "pattern" but it will be VERY difficult to avoid the final Carbon-fibre bridging in the corners and you may get corners that are only resin, with no fibres in there.. This will make the corners brittle, and compromise the strength of the bracket.

"Sapere Aude"... Dare to KNOW!

The written word is the only truly efficient vehicle for transmitting a complex concept from mind to mind...

103% of all people do not understand statistics...

Do not adjust our mind, theres a fault in reality :-)