Hi Lee,
Chemical release agents are too slippery to paint a Gell coat or resin on to. What should work is to apply the freecoat as recomended and then apply a coat or two of wax release agent. The wax will adhere to the Freecoat and the resin will adhere to the wax. This is a better release than wax only.

Brian.

Has anyone had this happen? This is the first time I have used a pigment additive in my epoxy and also the first time using a liquid mold release called Frekote 700nc. I was attempting to apply my first coat of epoxy to my plug as I have done on my first plug with good results. As soon as I started to brush it on, it started to separate. I was able to wipe it off very easly before it cured. However, I am wondering if it could have been the pigment additive.

This is only the second mold that I have done. The first one worked fine other than my plug construction, and plug surface quality was poor. So, this time, I did a lot research on construction techniques and proper plug surface requirements. After reading about different mold release types, I choose to use a liquid type. From what I have read, you can achieve a better molded part surface finish.

Any input would be great.

Thanks,

Lee Adams



Lee Adams

www.melleen.com

info@melleen.com