I have been working for a customer/friend on a new shell for his hill climb/sprint car. The plug is based on a Reliant Kitten shell. The new additions have been built up from ply and Kingspan boards followed by a layer of 450 CSM. A week of applying and sanding filler has resulted in a nice flat surface ready for 2K high build primer followed by 2k direct gloss. Then I shall start adding flanges, it will require an eight piece mould plus wheel arch returns. The final shell will be done in full carbon.

Warren

















Carbon Copies Ltd

Looks good.  The owner of a local garage near me has a Saab turbo powered spaceframed kitten.

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

  This one also runs a spaceframe and a very "trick" bored and stroked Honda S2000 lump. The shells will be available on a commercial basis if he fancy's one

Warren


Carbon Copies Ltd