Epoxy tooling gel coat - quite thick to apply.


Author
Message
Martin Fraser
Martin Fraser
Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)
Group: Forum Members
Posts: 11, Visits: 148
Hi folks,

I've posed this question in the mould making section a few days ago but I'm looking for a more definitive answer from you guys.

I've been using the above on my current project (model aircraft) and have been impressed with it's hardness when cured. But I find it's quite thick to brush on and doesn't flow very well, leaving quite an irregular surface .  Is it possible to thin it slightly so that it flattens out better?

Many thanks, Marty

Reply
Martin Fraser
Martin Fraser
Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)Supreme Being (155 reputation)
Group: Forum Members
Posts: 11, Visits: 148
Hi folks,

I hear what you're saying, I just thought it would be good to be able to brush it on and not have the 'ploughed field' contours left by the brush for the GF to follow.

I'll try a small amount and warm it slightly.




Thank guys, Marty
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...





Similar Topics

Reading This Topic

Explore
Messages
Mentions
Search