So I have done many infusions and they most of the time went ok.
only problem I had was because of heat the parts started getting some rpint though ( bike and car parts)

So I now wanted to post cure my parts in mould so it wont get print through anymore after its clearcoated and put on the bike or car.

I always use IN2 Epoxy Infusion Resin with fast harder or mixed fast and slow.

I got perfect vacuum droptested over night.
after part was infused I had the vacuum on until the resin was gelled up.
Got the part sitting 48H in room temp no signs of air in infusion mesh or anything.
than I had it in my oven for 3H at 40°C 

let it get to room temp and the part has print throug

mould was postcure to 90°C
and stil got mirror finish on it.