I'm tired of doing wet lay up for this, it's time to bag it.

Bearing mind that there is a "high point", where would be best to put the spiral? along one end and up to that high point? Or something else?  Would it need more layers of infusion mesh on the high "sides"? Any direction you guys could give would be appreciated.  I know that the flanges aren't large so I'd have to envelope bag the whole thing.

The reinforcement is 4 layers of 200 carbon if that makes a difference (the marks on the mould are just stray bits of peel ply that drifted on to it)

Hi,

I'm with Matthieu for the spiral around the entire edge.

For the process, I set the resin feed on the spiral, and vacuum port is in the middle (kinda) of the mold.

If you do it like Matthieu, the vacuum port should then be on the spiral.

Just a thought: you say that you are using 4 layers of 200g/sqm of cloth. Why not using a 200g/sqm layer for the cosmetic side, and 1 layer of 650 g/sqm for the backside? It would surely drop the costs down. But hey, I dont know what are your requirements.

Hope it helps.

 



 


    A $1000 electronic device will always protect a 10 cents fuse