+x scottracing - 5/30/2018 11:14:56 AMwhat layer height did you use on the PLA print? And did you sand it prior to the first coat of primer?The finished part looks brilliant, is that a flax/hemp material you made the part from?
+x Lester Populaire - 5/30/2018 9:24:47 PM+x scottracing - 5/30/2018 11:14:56 AMwhat layer height did you use on the PLA print? And did you sand it prior to the first coat of primer?The finished part looks brilliant, is that a flax/hemp material you made the part from?I usually print with a Layer height of 0.15 to 0.2mm and give it a light sand to get rid of small bumps where a new layer started and any things like that. Then usually two coats of heavy filler and one coat of finishing filler with wet sanding is enough to get a good finish.The part is made from Bcomp's ampliTex 5040 fabric.
+x KOSTAS - 9/12/2018 6:02:02 PM+x Lester Populaire - 5/30/2018 9:24:47 PM+x scottracing - 5/30/2018 11:14:56 AMwhat layer height did you use on the PLA print? And did you sand it prior to the first coat of primer?The finished part looks brilliant, is that a flax/hemp material you made the part from?I usually print with a Layer height of 0.15 to 0.2mm and give it a light sand to get rid of small bumps where a new layer started and any things like that. Then usually two coats of heavy filler and one coat of finishing filler with wet sanding is enough to get a good finish.The part is made from Bcomp's ampliTex 5040 fabric.0.15 layer height !!!! How many hours did it take you to print this bar mold ?