|
Group: Forum Members
Posts: 433,
Visits: 1.2K
|
When you draw a vacuum do not allow it to pull down tight at all.
So start to draw down the bag and stop the vacuum and then shove the carbon and peelply and infusion mesh into the corners the best you can.
Now draw down abit more vacuum stop and repeat pushing the materials into the corners.
Repeat in steps and you will feel the corners are in snug by the time you get full vacuum.
What ever you do make sure the mold is warm and the infusion resin is also warm before you infuse.
Hope this helps.
Fred
|