hi all, i'm having issues with the final part not wetting out enough consistently. I am using the same mould, same layers, same resin and temperature conditions. absolutely no leaks in the bag and obviously the same vac pump. it visually appears to infuse at the same rate every time but only 1/3rd of the time it's actually fully wetting out the weave. it seems to be luck of the draw for me? i'm using a low viscosity resin, pulling a vacuum for at least 40 mins before infusing. i've tried clamping off the vac line and resin line like the easy composites tutorial, i've also tried allowing the resin to almost empty the pottle and only clamping the resin line and allowing excess to reach the catchpot and letting it cure wit vaccuum pump going. also moving around the resin feed/vac lines. i honestly have no idea what the cause is. would appreciate any help here.

We tried clamping off the vac line first then waited a bit before the feed line, and indeed it did result in a much better finish!

We also gently warmed up the mould with a heat gun, and infused at a fairly fast rate without trying to slow it down by opening up the line clamp a little but instead had it fully opened. There were no pin-holes or wet out inconsistency in the final product which was a good feeling for once haha.