Small piece for my car

Author	Message
GTE-JOHN	GTE-JOHN posted 12 Years Ago HOT Topic Details
Group: Forum Members Posts: 6, Visits: 49	Since this is all new to me I thought I'd start off small & see how it went, so far not so good The part I chose to remake is pretty rare on my car model in the UK & sourced this from the Netherlands, since I'm on the uk owners club I have had a few people on there asking if I would also make them a copy of this part, So... 1st up I made & glued the flanges to it, figuring out where to put flanges to make the mould the easiest shape for releasing is a bit confusing at times, managed it 2nd time round, Then I used the yellow filleting wax & did my best to create a good draft angle all the way around, next step was the mould release wax, gave it a good coat, waited 5 mins & then buffed it off with a new clean cloth, After this I mixed up some gel coat & applied a layer, this is where the problems started, it seems to have reacted & separated in places, any help/tips on what to do next would be great, or do I have to start the whole thing again? Edited 12 Years Ago by GTE-JOHN
	Reply Like 2

Merge into selected topic...

Merge into merge target...

Merge into a specific topic ID...

GTE-JOHN - 12 Years Ago

[IMG]http://i92.photobucket.com/albums/l18/GTE-JON/null_zps091cc4e1.jpg[/IMG]...

GTE-JOHN - 12 Years Ago

Daz - 12 Years Ago

Daz - 12 Years Ago

Thanks for the info mate, sounds very useful

GTE-JOHN - 12 Years Ago

WilliamsHPF - 12 Years Ago

andygtt - 12 Years Ago

It should twist out from the bottom edge ok.

Warren (Staff) - 12 Years Ago

Login
Remember Me Reset Password Resend Validation Email Login	Facebook Google