Tube fit check please.

Author	Message
Vince	Vince posted 11 Years Ago Post Details
Group: Awaiting Activation Posts: 6, Visits: 40	Excellent. Thanks.
	Reply Like 1
Warren (Staff)	Warren (Staff) posted 11 Years Ago Post Details
Group: Administrators Posts: 2.5K, Visits: 8K	HI, I've just been out into the warehouse and the 12mm od pultruded tube slides into the 12.5mm ID Roll Wrapped tube fine. Likewise tube to box section. Warren Penalver Easy Composites / Carbon Mods - Technical Support Assistant
	Reply Like 1
Vince	Vince posted 11 Years Ago Topic Details
Group: Awaiting Activation Posts: 6, Visits: 40	Hi. I would like to use your 12mm protruded tube for a multicopter motor arm but would like to end up with a square end to hinge the arm. Looking at your sizes it would seem the best way to achieve this is :- 12mm (OD) protruded tube inside 12.5mm (ID) wrapped tube inside 20mm carbon box. I already have your 12mm protruded tube and it measures 12.3mm which may be a problem if the the 12.5mm ID wrapped tube is smaller than advertised. Could you please check the fit before I order. They will be glued together with epoxy. Thanks Vince
	Reply Like 1