Now I'm about ready to take a mould, I'm thinking ahead to the layup for the final part,

I'm planning to use the following - it's a 1.5m x 1m part

200g Pro-finish carbon
< not sure if this is required to avoid the white soric showing through> 195g carbon
2mm soric - trimmed just shy of the edges
carbon tape to build up the edge outside of the soric
195g carbon
vacuum bag


I'm not sure if I need the layer before the soric, and also not sure if I need peel ply or infusion mesh anywhere. The soric page says you just need:
Mould Surface | Reinforcement | Soric SF | Reinforcement | Vacuum Bag

But the tutorial video shows them using peel ply, and infusion mesh around the edge where the soric finishes


Any advice appreciated!
James