Hi, iv made a couple of small infusion part about 6inch long by 2inch.

Although the weave is nice and straight and no imperfections it isn't compressed nicely and can see gaps in the weave.

Mould was gel coated and left to cure, and then carbon laid with a mist of 3m 77 spray.

Also tried pro finish carbon.

Im thinking it's either glue on the carbon stopping it compressing in to place, or infused to fast because it's so small.

Resin is In2 fast

Any ideas.

Thanks

I think you have the same isseu as i had the first few times.

Infused to quick. I think.

Im a beginner allso. And i can remember verry well i did look and was amazed how fast the resin flowed. 

After a few trys i started looking a bit further and found to fast infusing traps small pockets of air in the dents of the material.