Hi all

Am making a router table and used Glascast 30 to get a smooth level finish. Most of the table is ok but part has gone a bit orange peely. But also, I thought I had enough to cover the table but I am approx 1mm short on depth in parts. So I need to top up.
Am I best to key sandpaper the layer I have put down to provide a key, or am I ok to pour more Glasscast 3 on top as is?

Many thanks.

Topping up is not a problem.  All you need to do is to key the surface with 120 grit paper and then give a thorough clean before re-coating with more GlassCast. 

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

+x

 

Warren (Staff) - 6/25/2019 8:37:56 AM

Topping up is not a problem.  All you need to do is to key the surface with 120 grit paper and then give a thorough clean before re-coating with more GlassCast. 

Many thanks Warren.
Anything in particular I should be cleaning with?

IPA wipes or acetone should be fine on fully cured resin. 

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant