+x

 

Interloper393 - 8/23/2017 10:09:55 AM

+x

 

Warren (Staff) - 8/22/2017 4:22:30 PM

You are better doing fins first as you can hide the overlap under the large main piece of carbon

How can you make seemless joins? Iv been trying on a few pieces now and can never get it right.. could you ex plain the process please

It's virtually impossible to make 'seamless joins' with any type of carbon fibre, including skinning with dry fabric - even when you use ProFinish. Instead, what you will normally need to do is either make a feature of the join (like bringing it together as a 'V' weave) or but the join on the inside or outside of a corner. When you put the join on a corner it's almost impossible to see and if you do notice it, it looks right.

Matt Statham
Easy Composites / Carbon Mods - Technical Sales

+x

 

Warren (Staff) - 8/22/2017 4:22:30 PM

You are better doing fins first as you can hide the overlap under the large main piece of carbon

How can you make seemless joins? Iv been trying on a few pieces now and can never get it right.. could you ex plain the process please

You are better doing fins first as you can hide the overlap under the large main piece of carbon


Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Aw ok I was going to do the main part first then the fins or go over the fins in one peice and have the join at the bottom off the fin could that work ?

Probably apply carbon in two stages. Stage one, cover all the fins, stage 2 cover the main diffuser part.


Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Hi all what would be the best way to skin this part
Would u cut at the side off the fins and join
https://goo.gl/images/ty5S54