Mould repair - Cleaning out non setting gelcoat/wax additive

Author	Message
Lenny	Lenny posted 9 Years Ago HOT Topic Details
Group: Forum Members Posts: 16, Visits: 58	I tried repairing my mould last night as there were a few pin holes in the surface. I therefore mixed up some tooling gelocat and wax additive and just filled in the holes. Its now almost 24 hours since and the repair areas are still a little tacky. I did use the correct ratio, but obviously something hasn't gone to process. Therefore, what is the best solution to fix this ? Do I wipe away the existing tacky repair and try and fill them again, or is there anything you can do to harden the existing repairs ?
	Reply Like 2

Merge into selected topic...

Merge into merge target...

Merge into a specific topic ID...

Lenny - 9 Years Ago

Give it some heat first,see if that kicks off the cure.

Shaneer22 - 9 Years Ago

Lenny - 9 Years Ago

Warren (Staff) - 9 Years Ago

Lenny - 9 Years Ago

MarkMK - 9 Years Ago

Login
Remember Me Reset Password Resend Validation Email Login	Facebook Google