Hi,

I intend to glue some of your 22.2mm ID CF Tube to a 3d printed part which I've been told is PA-2200 (Nylon). Going by your website, the PT326 adhesive seems most appropriate for the job. Can anyone please confirm whether that's correct and if not, which adhesive is best?

Thanks very much,

Sam.

Bonding to nylons is always difficult due to the low reactivity surface.

The glue I would recommend is our VuduGlu™ VM100 Black.

For best results you will need to key both surfaces and with the nylon use flame treatment to increase the reactivity of the surface.


Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Ok, thanks Warren. I'll make sure I get that stuff.

All the best.