1st attempt ok but a few problems


1st attempt ok but a few problems
View
Options
Author
Message
boustie
boustie
boustie
posted 13 Years Ago HOT
Supreme Being (114 reputation)Supreme Being (114 reputation)Supreme Being (114 reputation)Supreme Being (114 reputation)Supreme Being (114 reputation)Supreme Being (114 reputation)Supreme Being (114 reputation)Supreme Being (114 reputation)Supreme Being (114 reputation)
Group: Forum Members
Posts: 18, Visits: 92
Turned out ok ish for my first attempt but i have a slight issue where small areas of the resin have stuck to the steel mould i have.

Any ideas why this may be / pointers ?. Third picture shows the steel mould where the epoxy has stuck slightly.

I used 4 layers of carbon, wet lay with peel ply, release film, fabric and then vacuum bagged it

Thanks, Pete.

http://i230.photobucket.com/albums/ee247/boustie/IMAG15662.jpg
http://i230.photobucket.com/albums/ee247/boustie/IMAG1564.jpg
http://i230.photobucket.com/albums/ee247/boustie/IMAG1565.jpg
Reply Like 3
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
1st attempt ok but a few problems
boustie - 13 Years Ago
     thats 'funny' had a similar problem this weekend... but with a gelcoat that didnt cure and kept...
matthieutje65 - 13 Years Ago
     The resin seemed very slightly tacky when removing the peel ply, even though it had 24 hours to...
boustie - 13 Years Ago
     how many layers of carbon should i typically use, size is approx 12cm x 60cm. Part use as and engine...
boustie - 13 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search