I produced the mold no problem, and i waxed it several times before putting the PVA release on it. After pulling the finished part from the mold, half of the part was ok, the other part was still sticky resin, and gobs of resin were left inside the mold also.
I wanted to know if what i should use to get out the sticky gobs of resin out of the mold, and if theres any way to fix the part as well. My only guess to what went wrong is that it looks like there was less PVA on the area that has the sticky resin. This is my first attempt, and i would like to know what i did wrong and how to fix it. Thanks,

David

Ok, thank you. I got most of the mold clean with some acetone. Im going to wax it 10 times instead 4, like last time. I did leave the part at room temp (20 degrees celcius) for about 10 hours. I am guessing maybe that wasn't long enough, since the resin was still very sticky in most areas, (i thought it was just because i used to much resin). I am thinking maybe i can save the part also if i sand down the bad areas and add more resin on top? Or maybe not.