+x beliblisk - 11/8/2020 9:03:36 PMWhen removing orange peal most of the time you dont need to get it 100% flat (unless you are looking for glass like perfection). Its a pain in the ass to get all sanding marks out anyway so for larger stuff i just level area a bit to remove printrought from postcure and apply 2k UHS clear (and sometimes thats a problem on its own doe to mini pinholes). There is no "best method" and its just a question what gives good finish in as little time as possible. With cf there are a lot of possible ways to address imperfections from manufacturing (small mishaps happen) they just take time and you get better and faster over time For the record i hate trimming and sanding but uts all part of the job.
+x beliblisk - 11/8/2020 9:03:36 PMWhen removing orange peal most of the time you dont need to get it 100% flat (unless you are looking for glass like perfection). Its a pain in the ass to get all sanding marks out anyway so for larger stuff i just level area a bit to remove printrought from postcure and apply 2k UHS clear (and sometimes thats a problem on its own doe to mini pinholes). There is no "best method" and its just a question what gives good finish in as little time as possible. With cf there are a lot of possible ways to address imperfections from manufacturing (small mishaps happen) they just take time and you get better and faster over time For the record i hate trimming and sanding but uts all part of the job. Keep up the good work