Pin hole in gelcoat-what to do?

Author	Message
Classicarbon	C Classicarbon posted 6 Years Ago HOT Topic Details
C Group: Forum Members Posts: 86, Visits: 639	It's even smaller than pin head. -I was trying to repair but I think it's too small for gelcoat to stick. After sanding down it getting exposed again -Make it bigger for gelcoat to stick ? -or is it small enough to be sanded from the part after infiusion?
	Reply Like 5
Reply
Steve Broad	Steve Broad posted 6 Years Ago HOT Post Details
Group: Forum Members Posts: 408, Visits: 4.1K	+x Classicarbon - 4/19/2020 6:20:35 PM It's even smaller than pin head. -I was trying to repair but I think it's too small for gelcoat to stick. After sanding down it getting exposed again -Make it bigger for gelcoat to stick ? -or is it small enough to be sanded from the part after infiusion? As it will create an upstand in the finished part and you are planning to sand anyway I, personally, wouldn't worry about it. But I sand and paint all my carbon anyway :-)
	Reply Like 5