Options for mold? Help


Author
Message
Spiston21
S
Junior Member (6 reputation)Junior Member (6 reputation)Junior Member (6 reputation)Junior Member (6 reputation)Junior Member (6 reputation)Junior Member (6 reputation)Junior Member (6 reputation)Junior Member (6 reputation)Junior Member (6 reputation)
Group: Forum Members
Posts: 1, Visits: 202
Hello from the US. Sorry this is a relatively long read but if anyone can chime in on my options, it would be much appreciated. (First time writing this my phone froze and the text got deleted) I am currently making a mold for a vehicle hood and ran into a couple problems. I am attempting to turn my car into a full carbon car.

The first problem is, after completing the top half of mold, i trimmed the excess fiberglass using a hackzall to make molding the underside easier. It seems as though the vibrations loosened the hood in the mold. The front corners were sticking off the mold about 2-3mm. Everything else still sat flush.

The next problem is completely my fault 🤦‍♂️. Annoyed by this, and thinking that pva or filleting wax got wedged in somehow, I released the rest of the hood from the mold... after cleaning off the pva and wax, turns out the front corners still sit up about 2-3mm from the mold. I can push the corner down into place but it springs back. Pics will be posted later.

So My first question, is this 2-3mm difference worth scrapping the mold over? Everything else sits flush in the mold except the front two corners. If it’s worth redoing, is it a good idea to resecure the hood in the mold (no idea how to resecure the hood) and start with the underside? That way I can use the already existing flange?

The other question, does anyone have any ideas of how to resecure the already released hood back in the mold? I’m kind of at a loss here. I thought about reapplying pva and clamping the hood in the mold. But the pva will likely not dry of hold the mold down. My other thought was spray adhesive, but I am unsure if this will hold it down/ lead to difficulties eventually removing the hood from mold. If the mold is still worth salvaging I would like to resecure the hood in the mold before preceding.

Last question, is VE resin a better choice to use over tooling PE resin? Will it shrink less?

Unfortunately, I do not have affordable access to the uni molding system. Nor have I found a similar system available in the US. Epoxy is also out of my current price range. The mold bulk was made with unfilled tooling isophthalic poly resin. The manufacture claims it is a very low shrinkage resin meant for tooling. I added layers very slowly (never more than 2 per day) to prevent over heating of the resin.

-4layers of tooling poly gel goat was sprayed for a total of ~22mil
-after 3-4 hours the first layer of .75oz fiberglass mat was applied. The layer was allowed to cure for a minimum of 24hr.
-the surface was abraded and another layer of .75oz mat was added. Cured over night.
-surface was abraded, added a layer of 1.5oz mat. Cured over night
-surface was abraded, added a layer of 1.5oz mat. Cured over night
-surface abraded. Added two layers of 2oz. Cured over night.
-surface abraded added a layer of ~580 gsm biaxial +45/-45 that has .75oz mat stitched on the back. Let sit for 3-4 hours and Added cardboard tubes cut in half with 3 layers of 2oz mat to secure tubes using vinyl ester resin (ran out of poly).

Mold thickness is ~ .34-.40in depending on where the overlaps were.



Edited 5 Years Ago by Spiston21
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...





Similar Topics

Reading This Topic

Explore
Messages
Mentions
Search