I'm new to the forum and new to vacuum infusion.  I have some experience with fiberglass, doing structural repairs on my boats over the years, and also have made a fiberglass over foam boat - an 8 foot pram dinghy.  Mostly hand layup, but some vacuum bagging.

I am currently working on a larger project . . . an extended swim platform to add to my current boat, a 33 foot day boat.  I plan on using vacuum infusion and so, I have been studying up on the process.  So far I have made molds for 2 small hatches that will be used with the swim platform, using vacuum infusion. 

I'll post some questions in the appropriate sections.  Just wanted to stop into the introduction forum to say hello.

Regards,
tpenfield

Welcome to the Forum! There is a wealth of experience and knowledge around resin infusion on this forum so hopefully you will find the answers to your questions.


Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant