Hi,
I just tried to make a mould using the Unimould System, and was a bit surprised by the smell of the gel coat

Are there any other ways to make a mould but not evaporating so much unhealthy stuff?

Can this work?
1) Doing the moulds based on resin infusion out of glass or carbon fibres?
2) Epoxy Mould Making system? maybe it does not smell...

Of course I use the mask and the room is ventilated, nevertheless its still very smelly....

Thank you in advance for the answer

Thank you Warren,
1 more question with regards to the mould making based on resin. I will then use EG60 Epoxy Tooling Gelcoat. What should be the process if I want to use the woven glass on top? Few sentenced would be enogh, thank you in advance