Sorry el2 laminating resin

I always let the resin degassing for 10 mins and use a heat gun. .  Iv not sanded ot so it's not dust,  I'm using the lp2 resin us the xcr coati g resin better suited for skining. ? 

Sounds like tiny air bubbles or sanding dirt from the first layer of resin/carbon. Air bubbles can be got out using a heat gun wafted over the area.

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Yeah I'm using both of them buddy,  took 8 hours to go tacky :s

It depends on the temperature you are operating in.  If it was our AT30 Fast with EL2 then I would expected it to have got quite far into the gelling stage after 3 hours.

The only faster resin is our Epoxy Rapid Repair Resin which would normally at 20C be hard within 2 hours  so I would have thought should be firm but tacky within an hour. Although as it's so fast regular checking is needed!

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant

Hi guys is there a faster curing epoxy resin I can you for the Base coat?  Along the lines of say an hour?