I’ve been repairing a carbon-kevlar kayak. I had used alayer of West System 105 epoxy resin with 205 hardener but did not like all thebubbles that appear on adding the hardener and are v difficult to get rid of.After a cure period of more than a month I sanded to 80-grit and recoated witheasycomposites RapidRepair epoxy resin and fast hardener. When these are mixedthere are no bubbles – so preferable to the other brand!( I cleaned aftersanding with acetone but waited for that to dry before re-applying resin).Where I applied easycomposites resin on top of the West Systems resin, theeasycomposites resin did not harden fully and went slightly milky. I know I hadthe resin/hardener mix correct (100-33) because the mix hardened in the mixingcup and on parts of the kayak where there was no West System resin underneath.After waiting a couple of weeks for it to cure, I found it was still a bit stickyon the surface and although it had hardened it had the texture of polyethylenerather than a hard clear resin and could be peeled off with a paint scraperblade (luckily because it won’t sand off easily). So there was low adhesion tothe West Systems resin underlayer as well as the hardening issue. Has anyoneelse experienced this?