I have been working for a customer/friend on a new shell for his hill climb/sprint car. The plug is based on a Reliant Kitten shell. The new additions have been built up from ply and Kingspan boards followed by a layer of 450 CSM. A week of applying and sanding filler has resulted in a nice flat surface ready for 2K high build primer followed by 2k direct gloss. Then I shall start adding flanges, it will require an eight piece mould plus wheel arch returns. The final shell will be done in full carbon.

Warren

















Carbon Copies Ltd

Hi Warren & Andrew

Any updates on the shell? Keen to see some pics! 

Craig

Hi, slow job and we ain't got any spare time so might have to put the old shell back on for this season. I've done the bonnet then removed it from the mould, trimmed it to size and stuck it back on bagging tape then brushed it with pva. Done the roof and part of the front pillars, but run out off time as I'm up to my neck at work and got the engine swap, ecu, loom, tanks, ect to sort out. Need help!!!!!!!!!!!!! Also made the outer door skins....