Guys

I am after some advice please.

I've done a bit of wet layup and vacuum bag CF composite ( only simple stuff ! ) but am now looking to use infusion to create a flat panel ( approx 400mm x 900mm ) between two pieces of glass ( to be used as wing end plates on a hill climb car ). The construction would be :-

Gel coat-CF-Soric-CF-Gel coat

My question is, the two pieces of glass ( top and bottom mould ) will be larger than the composite stack so how do you stop the resin  taking the "easy route " around the composite stack and not wetting out the CF etc fully ? ( assuming the resin input is one end and the vacuum the other ).

Thanks in advance.

Adrian

So to be clear...The way to fix this would be to put another coat of easylease ( I did two allready) on the glass and then buff it off completly?  When you say buff it off is that just by hand rubbing until the surface is streak free? Or doI need to use any buffing products?  Just out of curousity why does that happen on glass and not on a gel coat mold? I applied the easylease the same way on the glass as I did on the tranny tunnel mold and there was no streaks on the tranny tunnel piece.  

Thanks,  Dennis