vacuum infusion details


vacuum infusion details
View
Options
Author
Message
suman
s
suman
posted 7 Years Ago HOT
Forum Guru (52 reputation)Forum Guru (52 reputation)Forum Guru (52 reputation)Forum Guru (52 reputation)Forum Guru (52 reputation)Forum Guru (52 reputation)Forum Guru (52 reputation)Forum Guru (52 reputation)Forum Guru (52 reputation)
Group: Forum Members
Posts: 11, Visits: 79
Hi i am trying to make laminates with  carbon fibres using vacuum infusion process. i would like to know is there any calculations involved related to how must vacuum to be set for a given size of laminates to be produced
Reply Like 5
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
vacuum infusion details
suman - 7 Years Ago
     You need to be pulling as close to full vacuum as your equipment can produce with resin infusion You might need to adjust the vacuum level if making parts via the wet-layed vacuum bagging process, s...
MarkMK - 7 Years Ago
     I did fabrication of glass/epoxy composites using vacuum infusion molding. after curing at the centre of the laminate i see poor wetting leaving behind dry patch. any suggestions to overcome it....
suman - 7 Years Ago
             To help ensure that your laminate is fully wet out during infusion you can take certain steps to help this, including: Ensure that you're infusing at a reasonable temperature (ideally at 20 degrees....
MarkMK - 7 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2024
Execution: 0.000. 3 queries. Compression Enabled.
Explore
Messages
Mentions
Search