Hi I have been building things from glass fiber for years and carbon more recently. And finally got round to joining this forum - Hello all. I wonder if anyone can offer some advice? Having been given a mould by a friend I am trying to make some carbon parts. The size of the part is approximate 20 - 10cm and is an internal car door escutcheon.  I originally though I could infuse the part but it is too small and fiddly for that (the problem I was having was holding all the reinforcement in place while i make it). So I was thinking a hand layup and then vac bagging - but then most of the time that would result in pinholes in the surface and possibly bridging from the non flexible nature of the peel-ply. How have others approached similar problems? 

if used in good amount, which mean as less as possible, and not spraying on the mouldside you shouldn't have problems

Matthieu Libeert
Founder MAT2 Composites X Sports
website: www.mat2composites.com