Hi I am new to resins and for a school project have got hold of a piece of yew wood. My plan is to encapsulate the sanded bit of yew within the clear resin. I am going to use the resin to fill out the edges of the wood so that it is square because the wood has a rough jagged edge with bark still on. The project is to be a coffee table. The rectangular size for the whole table will be 88x64x5cm so it is fairly large. I have calculated the amount of resin needed and will be roughly 5kg worth of it. I will make a plywood box for the mould lined with mould release. Is clear polyester resin suitable for this table and if so would I be able to do the resin in one go.

A lot of the "stabilizing" of woods are done using Acrylic resins, they can have almost as low viscosity as water.

I first ran into the use of Acrylic resins and vacuum for stabilizing soil samples for lab work, years ago at University.

"Sapere Aude"... Dare to KNOW!

The written word is the only truly efficient vehicle for transmitting a complex concept from mind to mind...

103% of all people do not understand statistics...

Do not adjust our mind, theres a fault in reality :-)