By Joe - 2/23/2012 7:00:40 PM
Hi there,
Regarding this new resin, I had a question:
I see its viscosity data on your website, and it varies very much (500-1200). Is it just an estimation data or ?
This question is asked, I bet you guessed it, to know if it will be able to go with the infusion process.
I know a 450-650 mPa.s like your High Temp resin can be used in infusion in small parts (see here).
Thanks EC for keep on adding new products to open people's range of possibilities.
|
By Matt (Staff) - 3/31/2012 9:40:50 AM
No worries Joe. I might make some samples up that I can send out to people or maybe do a very small sample sized pack so that people can do their own experiments without spending a lot of money on the full size pack. I'll keep you posted.
|
|