Talk Composites - The Forum for Advanced Composites

Mould for air intake

http://www.talkcomposites.com/Topic29321.aspx

By Barnsley-Bill - 9/8/2018 10:17:13 PM

Hi all I want to make a split mould for this air intake for my car out of Pre peg ' I bought the uni mould kit but have since found out its no good with the higher temps with the pre peg
Could I use the glass fiber mesh out of the uni mould kit with the high temp resin and the EG60 Epoxy Tooling Gelcoat .

or if not can you make a split mould using the tooling pre peg ?
By Barnsley-Bill - 12/13/2018 10:08:17 PM

 
Barnsley-Bill - 12/13/2018 10:02:09 PM

I made a new mould and this is my first go at pre peg ' I'm happy with the results but plan to make one more as one side looked like it was bridging as it was hard getting the vacuum bag in at both end without ripping it with my fingers I filled the dent/hole with Black epoxy filler then gave it a thin coat of clear.