Is it possible to knot .7mm CF tube

Author	Message
Clstrang	Clstrang posted 11 Years Ago HOT Topic Details
Group: Forum Members Posts: 2, Visits: 3	I want to attach this tubule by looping it over a small hook, and don't want to start bending it before I have some advice. Is it possible to knot this, and if so, what knot would be best?
	Reply Like 3
ajb100	ajb100 posted 11 Years Ago HOT Post Details
Group: Forum Members Posts: 346, Visits: 4.4K	Do you have a link to what you are referring too? Most likely you would not, as most resins used to make pre made parts are rigid, so would crack if you started bending them. Also carbon fibre does not like bending, and may snap the strands if the knot was tight. The only way I could think of trying it was by applying epoxy to dry carbon, wait until it tacks and then tie the knot, allowing the resin to cure in the shape needed
	Reply Like 3