Voids in Unimould surface

Author	Message
macgtech	macgtech posted 11 Years Ago Topic Details
Group: Forum Members Posts: 20, Visits: 102	Hi, I have made a mould for some headlight covers which I intend to layup using resin infusion, however there are some blemishes in the surface and the 'barriers' due to chips in the parts I have taken the mould from, along with a crack due to a slight gap between my plasticine barrier and the original part. Is it best to fill these using the Unimould Tooling Gelcoat (will it set if left out in the open?) or should/could I use the High Gloss Pattern Coat? Thanks MacG Racing Ltd., UK based Motorsport Racing Team - follow us on Twitter and on Facebook
	Reply Like 1
Reply
carbonfibreworks	carbonfibreworks posted 11 Years Ago Post Details
Group: Forum Members Posts: 292, Visits: 4.5K	Yes use the tooling gel coat and then you have two options to ensure it cures and one is to use this product https://www.easycomposites.co.uk/solution-mw-wax-gelcoat-additive (preferred method) or you can place some release tape over the gel coat. Regards Chris www.carbonfibreworks.co.uk Edited 11 Years Ago by carbonfibreworks
	Reply Like 1