Carbon Fibre Tubes


Carbon Fibre Tubes
View
Options
Author
Message
sahil.tfateh
sahil.tfateh
sahil.tfateh
posted 12 Years Ago HOT
Forum Member (38 reputation)Forum Member (38 reputation)Forum Member (38 reputation)Forum Member (38 reputation)Forum Member (38 reputation)Forum Member (38 reputation)Forum Member (38 reputation)Forum Member (38 reputation)Forum Member (38 reputation)
Group: Forum Members
Posts: 4, Visits: 24
I am planning to make A arms and the push-rods using carbon fibre tubes.
How should I chose the inner dia and outer dia of the tubes so as to avoid failure.
provided the forces are
1903.803297 front lower A
2166.240985 rear lower A
414.642784 front upper A
394.6610908 rear upper A
all forces in lbs

Edited 12 Years Ago by sahil.tfateh
Reply Like 2
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
Carbon Fibre Tubes
sahil.tfateh - 12 Years Ago
     get hold of a book and design them, do not use off the shelf pultruded tubes as they are not...
ChrisR - 12 Years Ago
     You will need to calculate the right tube specification. The basic data for our range of roll...
Warren (Staff) - 12 Years Ago
             how to calculate the tube specifications from the given load i am unable to find an approach could...
sahil.tfateh - 12 Years Ago
                 You need to calculate look at the arrangement you are going to use, calculate the forces (which you...
ChrisR - 12 Years Ago
     You need to derive it mathmatically. The figures given above are all relative to the surface area...
Warren (Staff) - 12 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search