Hello, 
I am going to make some Uni-mould moulds from original parts that are too light and delicate to see any heat or pressure. Then, I am going to make pre-preg parts from the moulds.

I just wondered what peoples experiences of this were...
What temperatures have you used the moulds to? What pre-preg have you used in the moulds? Etc...

In another thread, Hanaldo suggested an extended post cure which I intend to do. Someone else mentioned board sealer which could be a good shout as I have spray facilities for this.
I also have access to an autoclave for when I make the final part. Obviously, the integrity of the mould will come down to how well it is laminated but I was hoping to use a prepreg that might be a little more suited to OOA/lower temp cure. I have looked for VTF261 but may end up with VTC212 or similar. 
Any pointers on this will be much appreciated as I have a few projects coming up that would be suited to this process (if it works!)
Many thanks in advance!

Just remember that with a post cure, Uni-mould is designed to go up to 90C so use a pre-preg that is suited to low temperature cures on a vinylester surface. 

If the original part can't take heat, you are not limited to Uni-Mould, you can still use the EG160 tooling gel and EL160 resin or putty to make an epoxy high temperature cure.  The standard initial cure is at room temperature.

Warren Penalver
Easy Composites / Carbon Mods - Technical Support Assistant