Carbon fibre finishing with a sander


Carbon fibre finishing with a sander
View
Options
Author
Message
Mit123
M
Mit123
posted 5 Years Ago HOT
Forum Member (45 reputation)Forum Member (45 reputation)Forum Member (45 reputation)Forum Member (45 reputation)Forum Member (45 reputation)Forum Member (45 reputation)Forum Member (45 reputation)Forum Member (45 reputation)Forum Member (45 reputation)
Group: Forum Members
Posts: 7, Visits: 69
Hi,

I have skinned some car parts for my car using the XCR kit.

I have skinned quite alot of parts and have got to the final stage of finishing with 400-1200 grit sandpaper.

I am looking to speed up the process by using a sanding machine with the 400-1200 grit papers.

Which is a good sander to use?
Reply Like 2
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
Carbon fibre finishing with a sander
Mit123 - 5 Years Ago
     Any sander, it doesn't really matter. Air is better than electric for this sort of work, but you need a fairly capable compressor. Electric can work too if need be.
Hanaldo - 5 Years Ago
             Thank you so much for your response, I have ordered an electric sander/ polisher from Amazon with next day delivery. I will try it out tomorrow, hopefully it will cut down the time needed sanding an...
Mit123 - 5 Years Ago
     Hi guys, So I have tried sanding one of my parts. I used the following grits- 320, 600, 800, 1200, 1500, 2000. It gave me a decent result, but not up to the standard I was hoping for. The final...
Mit123 - 5 Years Ago
     Yes it could well be fine scratches from jumping the steps in paper too soon or not keeping the paper and part clean enough thus picking up a coarse bit of grit. I would do the 1500 and 2000 grit by....
Warren (Staff) - 5 Years Ago
     Yeh there really is a bit of an art to refinishing, it took me 6 years of doing composites professionally to get to a stage where I can polish parts and truly get rid of all scratches and swirls. It....
Hanaldo - 5 Years Ago
             Hi, when you refer to using a clear coat are you referring to using a spray can or to re-do the final coat of clear resin? Ive unfortunatley hit all of the parts in the 1st batch with 320 now so may...
Mit123 - 5 Years Ago
                 Also should I sand up to 800-1000 before applying the spray clear, to reduce any scratches from showing through?
Mit123 - 5 Years Ago
     Definitely spray, although I don't use a can. Cans are ok for small parts, but I would still highly recommend getting a 2k clear rather than just a single pack rattle can. The idea is that spraying....
Hanaldo - 5 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search