Group: Forum Members
Posts: 13,
Visits: 63
|
Hi all Almost ready to start laying up the mould on my plug, but wanted to know what the best combination of release agent(s) would be. Easylease, wax or PVA, or a combination of any of these? The plug measures 4400mm long and 600mm wide, and 250mm deep (with a 2 degree draw on the mould). It is basically flat, with a taper to one end on all faces. The plug is coated in cast acrylic, and will be polished to as good a finish as I can get... Any advice gratefully received
|