Woven Finish Carbon Fibre Tube 5mm O/D


Woven Finish Carbon Fibre Tube 5mm O/D
View
Options
Author
Message
offyman
o
offyman
posted 6 Years Ago HOT
Junior Member (15 reputation)Junior Member (15 reputation)Junior Member (15 reputation)Junior Member (15 reputation)Junior Member (15 reputation)Junior Member (15 reputation)Junior Member (15 reputation)Junior Member (15 reputation)Junior Member (15 reputation)
Group: Forum Members
Posts: 2, Visits: 5
I require a 4.8mm O/D finished size tube , concentric to the bore .. can you supply unfinished ground O/D material , for me to produce my own ground finished diameter ? Leaving me more material on than the 5mm size you supply ?

Thanks
Reply Like 3
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
Woven Finish Carbon Fibre Tube 5mm O/D
offyman - 6 Years Ago
     Hi Offyman, Unfortunately we do not manufacture the tubes in house so are unable to supply them part finished as you request.
Warren (Staff) - 6 Years Ago
             Thanks for the fast reply , can you give me an idea of standard concentricity ?, as if it is reasonable I still may have a chance of achieving my requirements. I've already ordered , some material i...
offyman - 6 Years Ago
     The tolerances on the tubes are +-0.1mm at that size. The pultruded tubes have no lacquer on them so you should be straight into the carbon. The woven finish tubes, it depends how thick the lacquer.....
Warren (Staff) - 6 Years Ago
     The woven finish tend not to be perfectly concentric (OD to ID) especially on the smaller diameters; by comparison, the pultruded tubes will have a much more accurate concentricity of the outside to....
Rich (Staff) - 6 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2024
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search