mould


mould
View
Options
Author
Message
111mattin111
111mattin111
111mattin111
posted 10 Years Ago HOT
Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)Supreme Being (449 reputation)
Group: Forum Members
Posts: 67, Visits: 910
HI everyone I'm currently working on taking a mould from my tailgate all the barriers are on taped over holes ect I just wondered if any of these will cause any problems when it comes to releasing the mould 

This is the where the glass sits  and has quite a sharp angle would it get stuck here 
Still need to add fillet wax yet

http://www.talkcomposites.com/Uploads/Images/7913de5e-65c7-4799-ba70-59b4.jpg
Edited 10 Years Ago by 111mattin111
Reply Like 2
GO

Merge Selected

Merge into selected topic...



Merge into merge target...



Merge into a specific topic ID...



Submit

Threaded View
Threaded View
mould
111mattin111 - 10 Years Ago
     Looks fine, though it's not easy to see from that picture. It's not much of a draft angle for...
Hanaldo - 10 Years Ago
             This pic is a little better you can see inside where the glass sits it's like that on 3 sides
111mattin111 - 10 Years Ago
     Should work ok. If you are worried you could kick the edge round and come out at 90deg to where you...
VVS - 10 Years Ago
     Thanks I've now put an angle on the flanges so hopefully I shouldnt have any problems
111mattin111 - 10 Years Ago
     Good work. if you think about it, when you turn it over and are looking into the actual mould you...
VVS - 10 Years Ago
     How long should I wait after putting the tooling coat on before I go ahead with the resin and 450csm...
111mattin111 - 10 Years Ago
     I normally try to layup between 6-24 hours later. Otherwise I give it a quick rub with 60 grit...
Hanaldo - 10 Years Ago
     Oh ok I did the coupling coat about 4 today so I should be OK to do the next stage in the morning?...
111mattin111 - 10 Years Ago
     As a home builder working in a non heated garage ive got a system going that's working well. I do...
VVS - 10 Years Ago
     Yeh with vinyl ester I don't think you'll have much issue with laying up the backing coats shortly...
Hanaldo - 10 Years Ago
     All done now just got to wait for it to fully cure
111mattin111 - 10 Years Ago

Similar Topics

Post Quoted Reply
Reading This Topic

Powered by InstantForum 2017-0 Final © 2025
Execution: 0.000. 2 queries. Compression Enabled.
Explore
Messages
Mentions
Search