Car rear spoiler support legs

Author	Message
Exocet	Exocet posted 10 Years Ago HOT Topic Details
Group: Forum Members Posts: 12, Visits: 119	hi, looking for some advice. I want to make some carbon fibre support legs for my car rear spoiler. The legs need to be approx 1 metre long, 200mm at the bottom tapering to 100mm at the top where it joints the spoiler. I have a vacuum infusion set up. Ideally I want both sides with a gloss finish. My plan was to use the following stack 200 grm 2/2 twill C/F and 2mm Soric as follows; C/F, soric, C/F, soric, C/F, soric, C/F All sandwiched between two pieces of glass (in order to get a gloss finish on both sides) This should end up about 5-6mm thick. Qus 1 do you think this would be strong enough? Qus 2 how can get radius on the leading edge / not end up with the exposed soric the the edges. Many thanks.
	Reply Like 4